Suzuki VZ800 Service Manual page 118

3-72 ENGINE
• Install the neutral switch.
• Install the oil pressure switch lead wire.
OIL FILTER
• Apply engine oil lightly to the gasket of the oil filter before
installation.
• Install the oil filter turning it by hand until feeling that the filter
gasket contacts the mounting surface. Then tighten it 2 turns
using the oil filter wrench. ( 20 N·m, 2.0 kgf-m, 14.5 lb-ft)
 09915-40610: Oil filter wrench
PRIMARY DRIVE GEAR
• Install the thrust washer 1 onto the crankshaft.
NOTE:
The chamfer side A of thrust washer 1 face crankcase side.
• Align the punch mark B on the crankshaft with the punch
mark C on the camshaft drive sprocket.
• Install the cam chain, cam chain tensioner 2, washers 3 and
spacer 4.
• Tighten the cam chain tensioner bolt to the specified torque.
 Cam chain tensioner bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)