Suzuki VZ800 Service Manual page 123

• Install the clutch drive plate No. 2 A first.
• Install the drive and driven plate one by one into the clutch
sleeve hub.
• Install the push rod.
• Install the clutch push piece 0, bearing A and thrust washer
B.
• Apply engine oil to the bearing.
• Install the springs and tighten the clutch spring set bolts diag-
onally to the specified torque.
 Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the new gasket C and dowel pins.
• Install the clutch cover and tighten the bolts.
NOTE:
Fit the new gaskets to the bolts B.
ENGINE 3-77