4-4 SHAFT DRIVE
REMOVAL
SECONDARY DRIVE BEVEL GEAR
The crankcase must be separated to service the secondary
drive bevel gear. The secondary drive bevel gear service
requires engine removal and disassembly. Refer to the engine
removal and the engine disassembly sections for secondary
drive bevel gear assembly removal.
Engine removal 3-3
Engine disassembly 3-11
SECONDARY DRIVEN BEVEL GEAR
The following components must be removed in the described
order before removing the secondary driven bevel gear.
NOTE:
Refer to the following pages for the details of each step.
• Remove the rear wheel. (8-33)
• Remove the swingarm. (8-40)
• Remove the universal joint.
• Remove the secondary driven bevel gear.
DISASSEMBLY
SECONDARY DRIVE BEVEL GEAR
• Compress the damper spring with a vice, and remove the snap
ring
with the special tool.
09900-06107: Snap ring pliers
• Remove the cam dog 1 and damper spring 2.
Do not attempt to remove the secondary drive bevel
gear bearing. The secondary drive bevel gear and its
bearing are available only as an assembly.