Suzuki VZ800 Service Manual page 317

DRIVEN JOINT
• Install the driven joint 1.
NOTE:
Apply grease to the O-ring and the final gear spline before
installing the driven joint.
 99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKI SUPER GREASE "A" (Others)
• Apply THREAD LOCK SUPER to the thread of driven joint
stopper bolts.
 99000-32030: THREAD LOCK SUPER "1303"
• Tighten the driven joint stopper bolts to the specified torque.
 Driven joint stopper bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Bend up the washer to lock the bolts.
REAR WHEEL
• Install the spacer 1.
• Apply grease to the final gear spline before installing the rear
wheel.
 99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKI SUPER GREASE "A" (Others)
• Remount the rear wheel spacer and rear axle.
• Install the washer and rear axle nut.
NOTE:
Refer to the page 8-31 for the spacer positioning.
• Install the torque link rod 2.
• Tighten the rear axle nut and torque link bolts and nuts to the
specified torque.
 Rear axle nut: 65 N·m (6.5 kgf-m, 47 lb-ft)
Torque link nut (Front): 35 N·m (3.5 kgf-m, 25.5 lb-ft)
(Rear) : 25 N·m (2.5 kgf-m, 18.0 lb-ft)
NOTE:
After remounting the rear wheel, check for proper brake opera-
tion. (2-21)
CHASSIS 8-37