Loading Pre-Drilled Stock In Trays 1, 2, 3, And 4 - Xerox D95 User Manual

Paper and other media
4. Load and align the edge of the tab paper against the RIGHT edge of the tray with
the side to be copied or printed on facing down.
Note
Tab stock can be loaded either long edge or short edge feed (portrait or landscape).
5. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
6. Gently push in the tray until it comes to a stop.
If enabled by your System Administrator, the Paper Tray settings screen may be
displayed on the UI.
7. If changes have been made to the paper tray, select the Change Settings button;
otherwise proceed to the next step.
a) Make the desired selections for the Paper Type/Paper Weight, Paper Size, and
Paper Color.
b) If necessary make the desired changes to the paper curl and alignment adjustment.
Note
Refer to the System Administration for detailed information on the paper curl and
alignment adjustment options.
c) Select Save until you are returned to the tray settings window.
8. Select Confirm to close the window.

Loading pre-drilled stock in trays 1, 2, 3, and 4

1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
5. Load and align the edge of the pre-drilled paper against the LEFT edge of the tray.
Align the paper so that the holes are against the left edge of the tray, and ensure
that the paper is loaded in the LEF direction.
3-4 ®
Xerox D95/D110/D125 Copier/Printer
User Guide