Specifications - Xerox D95 User Manual

High Capacity Stacker (HCS)
(continued)
Fault code Possible cause
049 970 Stacker limit or full sensor
fault
049 971
049 972
049 973 HCS falsely detects that the
Paper Unload button is
pressed.

Specifications

Paper guidelines
• Stacker Tray will accept 55-350 gsm (either coated or uncoated stock) with the
possibility of degraded stock quality and increased jam rate for stocks that are heavier
than 300 gsm.
• Transparencies may be run to either the Top Tray or the Stack Tray. Stack height
should be limited to 100 transparencies.
• Coated paper lighter than 100 gsm may not run as reliably as coated paper heavier
than 100 gsm.
• Non-standard papers longer than 305 mm (12 in.) in the feed direction require 210
mm (8.3 in.) minimum measurement across the feed direction.
• Non-standard papers shorter than 254 mm (10 in.) in the cross-feed direction require
330 mm (13 in.) minimum measurement in the feed direction.
20-16
Recommended solution
• Open the HCS front door.
• Remove any paper from stacker cart.
• Close front door
• If necessary, power Off/On the
machine
• If the problem still exists, contact the
Customer Support Center.
• Open the HCS front door.
• Remove any paper from stacker cart.
• Close front door
• If necessary, power Off/On the
machine
• If the problem still exists, contact the
Customer Support Center.
®
Xerox D95/D110/D125 Copier/Printer
User Guide