Rrp5.8 Guide Tray Left (Pl 7.1) - Oki B6500 Service Manual

RRP5.8 GUIDE TRAY LEFT (PL 7.1)
Removal
1) Remove the EP CARTRIDGE and Paper Cassettes.
2) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
3) Remove the COVER REAR (PL 1.1) (RRP1.1).
4) Remove the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
5) Remove the COVER LEFT (PL 1.1) (RRP1.3).
6) Remove the COVER RIGHT (PL 1.1) (RRP1.2).
7) Remove the COVER EXIT 500 (PL 1.1) (RRP7.1).
8) Remove the 500 EXIT ASSEMBLY (PL 7.1) (RRP7.2).
9) Remove the COVER TOP (PL 1.1) (RRP1.4).
10) Remove the COVER FRONT (PL 1.1) (RRP1.5).
11) Place the printer down on its left side.
12) Disconnect the HARNESS ASSEMBLY LVPS (PL 9.1) from the connector (P/J1821) of the GUIDE
TRAY LEFT (Figure 1).
13) Remove the 6 screws (gold tapping, 8mm x 1, gold, 6mm x 5) securing the GUIDE TRAY LEFT to
the frame (Figure 1).
14) Shift the GUIDE TRAY LEFT in the direction of the arrows (A) and (B), and remove it from the
frame (Figure 1).
Replacement
1) Shift the GUIDE TRAY LEFT in the opposite direction of the arrows (A) and (B), and install it to the
frame.
2) Install the GUIDE TRAY LEFT using the 6 screws (gold tapping, 8mm x 1, gold, 6mm x 5).
Be sure to tighten the screw (gold tapping, 8mm) shown as "Screw (A)" (Figure 1).
Chapter 3 Removal and Replacement Procedures (RRPs)
Figure 1. Left Tray Guide
3 - 88