Oki B6500 Service Manual page 28

Status Code Error Contents
STATUS 3-6 Paper Size Mismatch
STATUS 15-1 Xero Warning
STATUS 15-3 Near end of paper in Tray 4
STATUS 15-4 Near end of paper in Tray 3
STATUS 15-5 Near end of paper in Tray 2
STATUS 15-6 Fuser Life Warning
STATUS 16-1 Face Up Tray Fail
STATUS 16-3 Option Tray Unit Fail
STATUS 16-4 Full Stack (500 Paper Exit)
STATUS 16-5 Full Stack (OCT)
STATUS 17-1 Top/Rear Cover Open
STATUS 17-2 OCT Cover Open
STATUS 17-3 Duplex Cover Open
STATUS 17-4 Inappropriate Opt FDR
STATUS 17-5 OCT Unit Fail
STATUS 17-6 Duplex Unit Fail
STATUS 21-1 Illegal Size (Duplex/OCT)
STATUS 21-3 NO Paper in Tray 4
STATUS 21-4 NO Paper in Tray 3
STATUS 21-5 NO Paper in Tray 2
STATUS 21-6 NO Paper in Tray 1
Error Description
- Paper size detected by the Paper Size
Switch or set in the NVRAM does not
match the paper length obtained from ON
time of Regi Sensor at feeding.
- Remaining toner in EP CARTRIDGE
became low.
- Remaining paper in Tray 4 became low.
- Remaining paper in Tray 3 became low.
- Remaining paper in Tray 2 became low.
- Fuser printed more than 200,000 sheets
of paper.
- Face Up Tray is not correctly installed in
Duplex or OCT mode.
- Option Tray is not installed when Option
Tray is selected.
- 500 Paper Exit became Full Stack.
-Option OCT became Full Stack.
-COVER OPEN or COVER REAR 500 is
open.
- Cover of Option OCT is open.
-Cover of Option Duplex is open.
- Inappropriate Option Feeder
is detected.
- Option OCT is not installed when OCT
mode is selected.
- Option Duplex removed after powering
on.
- Paper size that is not supported in Duplex
or OCT mode is selected.
-No paper in Tray 4
-No paper in Tray 3
-No paper in Tray 2
-No paper in Tray 1
1 – 8
Chapter 1 Troubleshooting
FIP to be
referenced
FIP1.12
FIP1.16
FIP4.3
FIP4.3
FIP1.15
FIP1.17
FIP1.44
FIP4.4
FIP1.45
FIP3.6
FIP1.6
FIP3.1
FIP2.1
FIP4.5
FIP3.2
FIP3.7
FIP2.2
FIP2.7
FIP2.6
FIP3.5
FIP4.2
FIP4.2
FIP1.14
FIP1.14