Installing The Expansion Tray Unit - Oki COREFIDO B822dn User Manual

16
Press ▲ or ▼ to input the admin password, and press «OK».
Admin Password(P.207)
17
Check that [Network Setup] is selected, and press «OK».
18
Press ▼ several times to select [Wired(LAN2) Setup], and press «OK».
19
Check that [Wired(LAN2)] is selected, and press «OK».
20
Check that [Enable] is selected, and press «OK».
Next, set network information like the IP address on this machine.
2. Setting the IP address,

Installing the expansion tray unit

The machine may tip over. Be sure to attach the supplied connecting parts.
Install the expansion tray unit if you want to increase the amount of paper that can be loaded. After installation,
set the number of trays in the printer driver.
There are two types of trays: expansion tray unit and expansion tray unit (large). Up to 3 expansion tray units
can be installed in total. Be sure to attach the supplied connecting parts.
To install 3 expansion tray units, the optional Caster Base is recommended.
Installing the Caster Base(P.36)
A flat-head screwdriver is required to install the expansion tray unit.
etc.(P.47)
Preparing and connecting this machine to your PC
Injury may be caused.
- 32 -