Rrp7.14 Gate Fuser (Pl 7.2) - Oki B6500 Service Manual

RRP7.14 GATE FUSER (PL 7.2)

Removal
1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
2) Remove the 5 screws (gold tapping, 6mm) securing the CHUTE LOW FU (PL 7.2) to the COVER
REAR 550.
3) Release the hooks of the COVER REAR 550, and remove the CHUTE LOW FU from the COVER
REAR 550.
4) Remove the LEVER GATE HOLDER (PL 7.2),SPRING LEVER GATE (PL 7.2), and LEVER GATE
FU (PL 7.2) (RRP7.11).
5) Remove the 2 screws (gold tapping,6mm) securing the CHUTE UP FU (PL 7.2).
6) Remove the GATE FU (PL 7.2) from CHUTE LOW FU (PL 7.2) by bending GATE FU (PL 7.2)
(Figure 1).
Be careful handling the GATE FU. It is fragile and could break if given excessive force.
Replacement
1) Install the GATE FU (PL 7.2) to CHUTE LOW FU (PL 7.2) (Figure 1).
2) Secure the CHUTE UP FU using the 5 screws (gold tapping, 6mm).
3) Install the LEVER GATE HOLDER (PL 7.2), SPRING LEVER GATE (PL 7.2), and LEVER GATE
FU (PL 7.2) (RRP7.11).
4) Install the ROLL FU to the BEARING EXIT (PL 7.2) on the opposite side of the GEAR 21 (PL 7.2)
by shifting the ROLL FU in the opposite direction of the arrow.
5) Install the CHUTE LOW FU to the COVER REAR 550, and secure it with the hook.
6) Secure the CHUTE LOW FU to the COVER REAR 550 using the 5 screws (gold tapping, 6mm).
7) Install the COVER REAR 500 (PL 7.1) (RRP7.9).
Chapter 3 Removal and Replacement Procedures (RRPs)
Figure 1. Fuser Gate
3 - 136