Oki B6500 Service Manual page 248

Replacement
1) Shift the ROLL REGI RUBBER in the opposite direction of the arrow, and install it to the 150
FEEDER ASSEMBLY.
When installing, do not touch the roller surface of the ROLL REGI RUBBER.
Install the ROLL REGI RUBBER so that its D-cut is positioned at the BEARING REGI
RIGHT side.
2) Install the BEARING REGI RIGHT (PL 4.1) to the ROLL REGI RUBBER.
The shapes of the flange and the positions of the hook are different on the BEARING
REGI RIGHT (white) and BEARING REGI LEFT (black).
3) Turn the BEARING REGI RIGHT in the opposite direction of the arrow, and install it to the CHUTE
REGI.
4) Install the BEARING REGI LEFT (PL 4.1) to the ROLL REGI RUBBER.
The shapes of the flange and the positions of the hook are different on the BEARING
REGI RIGHT (white) and BEARING REGI LEFT (black).
5) Turn the BEARING REGI LEFT in the opposite direction of the arrow, and install it to the CHUTE
REGI.
6) Clip the E-ring to the ROLL REGI RUBBER to secure the BEARING REGI LEFT.
7) Install the GEAR REGI RUBBER (PL 4.1) to the ROLL REGI RUBBER, and secure it using the E-
ring.
8) Hang 2 SPRING REGIs (PL 4.1) to the CHUTE REGI (PL 4.1) and BEARING REGI RUBBER.
When hanging the SPRING REGIs, make sure that the SPRING REGIs are hung to the
boss of the CHUTE REGI, and to the inside of the hooks of the BEARING REGI LEFT
and BEARING REGI RIGHT.
After hanging the SPRING REGIs, make sure the SPRING REGIs have not pinched the
HARNESS ASSEMBLY TONER 2 (NOTE 2) (Figure 1).
9) Install the CLUTCH REGI (PL 4.1) (RRP4.6).
10) Install the 150 FEEDER ASSEMBLY (PL 4.1) (RRP4.1).
11) Install the CHUTE TRANSFER (PL 6.1) together with the BTR ASSEMBLY (RRP6.9).
Do not tighten the screw to the left side hole of the CHUTE TRANSFER.
12) Install the COVER REAR (PL 1.1) (RRP1.1).
There are 2 kinds of screws, make sure they are installed correctly.
13) Install the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
14) Install the COVER REAR 500 (PL 7.1) (RRP7.9).
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 64