Fip1.9 Paper Jam/Tray To Regi - Oki B6500 Service Manual

FIP1.9 Paper Jam/Tray to Regi

Step
Possible causes:
150 FEEDER ASSY (PL5.1.1)
150 PAPER CASSETTE (PL2.1.50)
SENSOR REGI (PL5.1.30)
ACTUATOR B (PL5.1.17)
CHUTE ASSY FDR1 (PL5.1.3)
HVPS/MCU (PL12.1.19)
LVPS (PL12.1.5)
CHUTE ASSY FDR2 (PL7.1.21, PL20.2.2)
CLUTCH ASSY PH (PL5.1.21, PL7.1.20, PL20.2.21)
ROLL ASSY RETARD (PL2.1.2, PL4.1.2, PL20.3.2)
CLUTCH PR-REGI (PL20.2.22)
550 FEEDER OPION (PL20.2.1)
550 FEEDER ASSY (PL7.1.10)
550 PAPER CASSETTE (PL4.1.50)
Checking the paper size setup.
1 Does the paper size in use match the size setup by
GUIDE ASSY END or by the driver on the PC?
2 Does Error occur when the power is turned ON?
Checking the paper at ACTUATOR B.
3 Does the paper remain at ACTUATOR B of SENSOR
REGI?
4 Does Error occur when the power is turned ON?
Checking ROLL ASSY RETARD.
Is ROLL ASSY RETARD not damaged, and installed
5 correctly?
Check the operation of it assembled each Paper Cas-
sette.
Run a test print.
Does Error occur, when the test printing is performed
with the paper supplied from the Tray 1 or Tray 2?
With the Option 550 Paper Feeder is installed, does
6
Error occur, when the test printing is performed with the
paper supplied from the Tray 3 or Tray 4?
Check using Chapter 2 Diagnostic [TEST PATTERN
MODE MENU].
Checking the paper position
Remove EP CARTRIDGE.
7
Does the front end of paper touch Actuator B of SEN-
SOR REGI?
Checking a tray feeding the paper
8 When running a test print, is the paper supplied from
Tray 1 or Tray 2?
Checking CLUTCH ASSY PH for operation
Does CLUTCH ASSY PH operate normally?
9
Check using Chapter 2 Diagnostic [Tray1/2 Feed
Clutch Test].
Check
1 – 22
Chapter 1 Troubleshooting
Yes
Replace the paper,
Go to step 2. or change the
paper size setup.
Go to step 3. Go to step 5.
Remove the
Go to FIP1.28
paper, and go to
SENSOR REGI.
step 4.
Go to FIP1.28
Go to step 5.
SENSOR REGI.
Replace ROLL
ASSY RETARD
Go to step 6.
(RRP2.1, 4.1,
Go to step 7. End of work
Go to FIP1.28
Go to step 8.
SENSOR REGI.
With tool Go to
step 9. Without
Go to step 11.
tool Go to step
10.
Go to FIP1.39
Go to step 11. CLUTCH ASSY
No
20.17)
PH.