Oki B6500 Service Manual page 330

2) Install the boss which is under the connector of HARNESS ASSEMBLY FUSER to the frame (Fig-
ure 1).
3) Install the GEAR ASSEMBLY PLATE to the frame using the 4 screws (silver, 6mm) (Figure 1).
When installing, if the GEAR or the SPRING that are not fixed to the GEAR ASSEMBLY
PLATE come off, re-install them in the direction shown in the figure.
4) Install the GEAR ASSEMBLY HOUSING (PL 8.1.3) (RRP8.3).
When installing, two of the gears that are installed to the GEAR ASSEMBLY HOUSING
are not fixed and they may come off. Be careful not to drop them.
When installing, engage the gears of the GEAR ASSEMBLY HOUSING, MAIN MOTOR,
and GEAR ASSEMBLY PLATE. After assembling, check the engagement of the gears.
The gears will engage easily when they are assembled, by rotating the MAIN MOTOR
with hand.
5) Insert the boss of the bottom side of the connector of the HARNESS ASSEMBLY FUSER to the
frame.
6) Install the COVER LEFT (PL 1.1) (RRP1.3).
7) Install the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
8) Install the COVER REAR (PL 1.1) (RRP1.1).
There are 2 kinds of screws, make sure they are installed correctly.
9) Install the COVER REAR 500 (PL 7.1) (RRP7.9).
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 146