Rrp5.4 Gear Nudger (Pl 5.1.18) - Oki B6500 Service Manual

RRP5.4 GEAR NUDGER (PL 5.1.18)
Removal
1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
2) Remove the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
3) Place the printer down on its left side.
Be careful not to scratch the cover, and do not drop the printer.
4) Open the COVER OPEN (PL 1.1).
5) While lifting up the boss of the HOLDER LEFT (PL 5.1) at the back of the 550 FEEDER ASSEM-
BLY, shift the HOLDER LEFT in the direction of the arrow to remove 3 hooks (Figure 1).
6) Remove the HOLDER LEFT from the SUPPORT NUDGER (PL 5.1). At the same time, the ACTU-
ATOR NO PAPER (PL 5.1) is removed (Figure 1).
7) Release the hook securing the ROLL ASSEMBLY NUDGER (PL 5.1), and pull it out from the
SHAFT NUDGER (PL 5.1) (Figure 1).
When removing, do not touch the roller surface of the ROLL ASSEMBLY NUDGER.
8) Release the hook securing the GEAR NUDGER, and pull it out from the SHAFT NUDGER.
When removing, do not touch the roller surface of the GEAR NUDGER.
SUPPORT
NUDGER
(PL7.1.12)
ACTUATOR
NO PAPER
(PL7.1.14)
LIFT UP
(BOSS)
HOLDER
LEFT(PL7.1.13)
LIFT UP
(BOSS)
HOOK
HOLDER
LEFT
Figure 1. Nudger Gear
Chapter 3 Removal and Replacement Procedures (RRPs)
ROLL ASSY NUDGER
(PL7.1.19)
GEAR NUDGER
(PL7.1.18)
SUPPORT
NUDGER
(PL7.1.12)
ACTUATOR
NO PAPER
3 - 80
HOOK
HOLDER
LEFT
JG3051AA