Rrp8.4 Gear Assembly Plate (Pl 8.1.10), Gear 9 (Pl 8.1.9) - Oki B6500 Service Manual

RRP8.4 GEAR ASSEMBLY PLATE (PL 8.1.10), GEAR 9 (PL 8.1.9)
Removal
1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
2) Remove the COVER REAR (PL 1.1) (RRP1.1).
3) Remove the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
4) Remove the COVER LEFT (PL 1.1) (RRP1.3).
5) Remove the GEAR ASSEMBLY HOUSING (PL 8.1.3) (RRP8.3).
6) Remove the 4 screws (silver, 6mm) securing the GEAR ASSEMBLY PLATE to the frame (Figure
1).
7) Remove the GEAR ASSEMBLY PLATE (Figure 1).
8) Remove the boss of the bottom side of the connector of the HARNESS ASSEMBLY FUSER from
the frame (Figure 1).
9) Remove the GEAR 9 (PL 8.1.9) from the shaft on the frame (Figure 1).
When removing the GEAR ASSEMBLY PLATE, one of the gears installed to the GEAR
ASSEMBLY PLATE is not fixed and it may come off. Be careful not to drop it.
There is a SPRING inside of the GEAR that is not fixed to the GEAR ASSEMBLY PLATE.
Be careful not to drop this SPRING.
Replacement
1) Install the GEAR 9 (PL 8.1.9) to the shaft on the frame (Figure 1).
When installing the GEAR 9, be sure to install the narrow end of the GEAR inside.
Chapter 3 Removal and Replacement Procedures (RRPs)
Figure 1. Gear 9 & Gear Plate Assembly
3 - 145