Rrp12.14 Clutch Assy Ph (Pl12.2) - Oki B6500 Service Manual

RRP12.14 CLUTCH ASSY PH (PL12.2)

Removal
1) Remove the 550 FEEDER OPTION (PL 12.2). (RRP12.1)
2) Remove the 6 screws (gold taping, 8mm) securing the PLATE TIE (PL 12.2.29).
3) Remove the PLATE TIE from the CHUTE OUT (PL 12.2.25).
4) Disconnect the connector (P/J853) of the CLUTCH ASSY PH from the HARNESS ASSY
CLSNR1 (PL 12.2.31).
5) Remove the E-ring securing the CLUTCH ASSY PH, and remove the CLUTCH ASSY PH from
the SHAFT FEED (PL 12.2.16).
WHEN ASSEMBLING
CONNECTOR
Replacement
1) Install the CLUTCH ASSY PH to the SHAFT FEED (PL 12.2.16), and secure it with the E-ring.
When installing, make sure that the notch of the CLUTCH PH is combined with the boss
of the CHUTE OUT.
Be careful of the arranging of the harness of the CLUTCH ASSY PH.
Chapter 3 Removal and Replacement Procedures (RRPs)
CHUTE OUT
(PL20.2.25)
CHUTE OUT
3 - 234
Note 1)
CLUTCH ASSY PH
(PL20.2.21)
PLATE TIE
(PL20.2.29)
JG3515AB