Troubleshooting And Tips; Diagnosing Switch Indicators; Accessing The Management Interface - Fujitsu Siemens Computers PRIMERGY BX Description

Accessing the Management Interface

10 Troubleshooting and Tips

If you are having problems connecting to the network, check your network cabling to ensure
that the device in question is properly connected to the network. Then refer to verify that the
corresponding port on the switch is functioning properly.
If you are having problems connecting to the management interface, refer to the troubleshooting
chart.

10.1 Diagnosing Switch Indicators

If you have a connected a device to a port on the switch, but the Link LED is off, then check the following items:
Verify that the switch and attached device are powered on.
Be sure the cable is plugged into both the switch and corresponding device.
Verify that the proper cable type is used and its length does not exceed specified limits.
Check the adapter on the attached device and cable connections for possible defects. Replace the
defective adapter or cable if necessary.
Verify that all system components have been properly installed. If any network cabling appears to be
malfunctioning, test it in an alternate environment where you are sure that all the other components are
functioning properly.
10.2 Accessing the Management Interface
You can access the management interface for the switch from anywhere within the attached
network using Telnet, a Web browser, or any SNMP-based network management software. If
you are having trouble accessing the management interface, then refer to the troubleshooting
information displayed in the following table.
673
Troubleshooting and Tips
Lan Switch and Router Blade