Configuration Commands - Fujitsu Siemens Computers PRIMERGY BX Description

Distance Vector Multicast Routing Protocol (DVMRP) Commands
None
Command Mode
Privileged Exec
User EXEC
Display Message
Source Address This field displays the multicast address of the source group.
Source Mask This field displays the IP Mask for the source group.
Upstream Neighbor This field indicates the IP Address of the neighbor which is the source
for the packets for a specified multicast address.
Interface This field displays the interface used to receive the packets sent by the sources.
Metric This field displays the distance in hops to the source subnet. This field has a different
meaning than the Interface Metric field.
Expiry Time(secs) This field indicates the expiry time in seconds. This is the time remaining
for this route to age out.
Up Time(secs) This field indicates the time when a specified route was learnt, in seconds.

7.27.2 Configuration Commands

7.27.2.1 ip dvmrp
This command sets administrative mode of DVMRP in the router to active. IGMP must be
enabled before DVMRP can be enabled.
Syntax
ip dvmrp
no ip dvmrp
no - This command sets administrative mode of DVMRP in the router to inactive. IGMP
must be enabled before DVMRP can be enabled.
Default Setting
Disabled
Command Mode
Global Config
7.27.2.2 ip dvmrp metric
This command configures the metric for an interface. This value is used in the DVMRP
messages as the cost to reach this network.
619
Command Reference
Lan Switch and Router Blade