Configuration Commands - Fujitsu Siemens Computers PRIMERGY BX Description

CoS (Class of Service) Command
Command Mode
Privileged EXEC
Display Message
Interface This displays the slot/port of the interface. If displaying the global configuration,
this output line is replaced with a Global Config indication.
Interface Shaping Rate The maximum transmission bandwidth limit for the interface as a
whole. It is independent of any per-queue maximum bandwidth value(s) in effect for the
interface. This is a configured value.
The following information is repeated for each queue on the interface.
Queue Id An interface supports n queues numbered 0 to (n-1). The specific n value is
platform dependent.
Minimum Bandwidth The minimum transmission bandwidth guarantee for the queue,
expressed as a percentage. A value of 0 means bandwidth is not guaranteed and the
queue operates using best-effort. This is a configured value.
Scheduler Type Indicates whether this queue is scheduled for transmission using a strict
priority or a weighted scheme. This is a configured value.
Queue Mgmt Type The queue depth management technique used for this queue, either
tail drop or weighted random early discard (WRED). This is a configured value.

7.17.2 Configuration Commands

7.17.2.1 queue cos-map
This command maps an 802.1p priority to an internal traffic class on a "per-port" basis.
Syntax
queue cos-map <0-7> <0-7>
no queue cos-map
< 0-7 > - The range of queue priority is 0 to 7.
< 0-7 > - The range of mapped traffic class is 0 to 7.
no - Reset to the default mapping of the queue priority and the mapped traffic class.
Default Setting
None
Command Mode
Interface Config.
533
Command Reference
Lan Switch and Router Blade