Comtech EF Data LPOD Installation And Operation Manual page 141

LPOD Outdoor Amplifier / Block Up Converter (BUC)
Serial-based Remote Product Management
Command Arguments
(Instruction for Command
Parameter Type
Code and or Response
Qualifier) to Query
SNMP SNA= 1 byte
Authentication
Trap
Enable
SNMP SNM= 1 byte
Enable
Serial Number N/A 9 bytes
Remote Address SPA= 4 bytes
SNMP Read SRC= 16 bytes,
Community characters, no
spaces
SNMP SSC= 255 bytes,
System Contact characters,
Set Statistics SSI= 2 bytes
Interval
Description of Arguments
(Note that all arguments are printable ASCII characters)
Command or Query.
Sets or returns the SNMP Authentication in the form x, where:
0=Disabled
1=Enabled
Example: <1/SNA=0
Command or Query.
Sets or returns SNMP in the form x, where:
0=Disabled
1=Enabled
Example: <1/SNM=0
Query only.
Returns the unit's nine-digit serial number in the form xxxxxxxxx
Note: this command is functionally identical to RSN.
Example: <1/SNO?'cr'
>0001/SNO=072282040'cr''lf'
Command or Query.
Sets or returns the Physical Address in the form xxxx, where:
xxxx = 0001 to 9999, resolution=0001
Default value: 0001
Example: <1/SPA=0412'cr'
>0001/SPA='cr''lf'
Command or Query.
Sets or returns the SNMP Read Community string. Empty string is not allowed
Example: <1/SRC=public
Command or Query.
Sets or returns the SNMP System Contact string.
Example: <1/SSC=Joe Net Admin.
If not configured it returns empty string: <1/SSC=
Command or Query.
Sets or returns the interval at which statistics are logged, in the form xx, where:
xx = 01 to 99 minutes, resolution is in 01 minute increments
Default value: 90
Example: <1/SSI=90'cr'
>0001/SSI='cr''lf'
5–33
Revision 9
MN-LPOD
Response to Query
Response to Query
Command (Instruction
(Target to
(Target to Code and
Controller)
Controller) Qualifier)
SNA= SNA? SNA=x
SNA? (See Description of
Arguments)
SNM= SNM? SNM=x
SNM? (See Description of
Arguments)
SNO= SNO? SNO=xxxxxxxxx
(See Description of
Arguments)
SPA= SPA? SPA=xxxx
SPA? (See Description of
SPA* Arguments)
SRC = SRC? SRC =x
SRC! (see Description of
Arguments))
SSC = SSC? SSC =x [1..128]
SSC! (see Description of
Arguments)
SSI= SSI? SSI=xx
SSI? (See Description of
Arguments)