Comtech EF Data LPOD Installation And Operation Manual page 88

LPOD Outdoor Amplifier / Block Up Converter
Ethernet-based Remote Product Management
System Account Access Information
• Admin, Read/Write, and Read Only Names and Passwords:
The factory defaults for these names/passwords are:
o Admin
o Read/Write
o Read Only
Note the following:
o These Name fields can be any alphanumeric combination with a maximum length of
10 characters.
o These Password fields can be any alphanumeric combination with a maximum
length of 10 characters.
•
SMTP Server: Specify the mail server IP address from where you want to send the e-mail.
•
SMTP Domain Name / Destination: The Administrator can assign the SMTP Domain Name
and Destination. This is required if you wish to use the Home | Support page e-mail feature
(Sect.4.5.4.1.3).
o For SMTP Domain Name, specify the domain of the e-mail server (usually found to
the right of the @ symbol in an e-mail address).
o For SMTP Domain Destination, specify the e-mail recipient name (usually found to
the left of the @ symbol in an e-mail address).
Click [Change Access] to save any changes. Otherwise, click [Reset] to revert to the previously
assigned System Account Access Information.
Webpage Timeout
The Webpage Timeout determines a desired time lapse before the LPOD Web Server Interface
pages time out. Use the drop-down list to select five minutes or eight hours. The default
timeout setting is five minutes. Click [Submit] when done.
The 'Status | Status' page (Figure 4-11 in Sect. 4.5.4.4.2) will automatically
refresh once every ten seconds, and will reset the timeout counter.
comtech/comtech
opcenter/1234
monitor/1234
4–16
Revision 9
MN-LPOD