Comtech EF Data LPOD Installation And Operation Manual page 130

LPOD Outdoor Amplifier / Block Up Converter (BUC)
Serial-based Remote Product Management
Command Arguments
(Instruction for Command
Parameter Type
Code and or Response
Qualifier) to Query
Local/Remote LRS= 1 byte
State
Unit MAC Address N/A 17 bytes
Description of Arguments
(Note that all arguments are printable ASCII characters)
Command or Query.
Sets or returns Local or Remote state for Indoor SSPA (always in remote mode for Outdoor SSPA) in the form x,
where x=0, 1, 2, or 3::
0 = Local
1=Serial
2=Ethernet
3=Serial+Ethernet (default value)
Note: The user will always have query access in any mode. The LRS command is also available in all modes as
a means of acquiring control. The intent of this command is to limit changes from being made on multiple
interfaces at the same time. Units without a front panel will treat an entry of 0 as reserved, and will refuse the
command by returning a mode error. The web page GUI will refuse connections unless LRS is set to enable
Ethernet remote control.
Example: <1/LRS=3'cr'
>0001/LRS='cr''lf'
Query only.
Returns the MAC address of the unit, in hexadecimal format xx-xx-xx-xx-xx-xx
Example: <1/MAC?'cr'
>0001/MAC=00-06-B0-00-D2-A7'cr''lf'
5–22
Revision 9
MN-LPOD
Response to Query
Response to Query
Command (Instruction
(Target to
(Target to Code and
Controller)
Controller) Qualifier)
LRS= LRS? LRS=x
LRS? (See Description of
Arguments)
MAC= N/A MAC=xx-xx-xx-xx-
xx-xx
(See Description of
Arguments)