Config | Redundancy; Figure 4-9. Config | Redundancy Page - Comtech EF Data LPOD Installation And Operation Manual

LPOD Outdoor Amplifier / Block Up Converter
Ethernet-based Remote Product Management
4.5.4.3.4

Config | Redundancy

Appendix A. 1:1 REDUNDANCY
Use this page to configure the LPOD's Redundancy Switch Mode.
Click [Refresh] (at the top of the page) to update the page appearance to the current operating
configuration.
Redundancy
To update the page to the current redundancy configuration: Click [Refresh].
Enable Redundancy Switch Mode
Use the drop-down list to select the Switch Mode as follows:
•
Off – Disables redundancy.
• 1:1 Red TX – Enables 1:1 redundancy with transmit switch control.
•
1:1 Red TX+RX – Enables 1:1 redundancy with transmit and receive switch control.
• Manual: Enables manual redundancy mode.
Click [Change] once the desired mode selection has been made.
Online Status
This read-only section displays the active status for the unit as either Online or Offline.
Force Online
To force a unit to go active (online): Click [Force Online].

Figure 4-9. Config | Redundancy Page

4–23
Revision 9
MN-LPOD