LPOD Outdoor Amplifier / Block Up Converter (BUC)
Appendix B
B.3.1
RF Cable (Type 'N')
Use this Type 'N' cable for the Rx or Tx connections in LPOD Standalone or 1:1 Redundancy applications:
•
For LPOD PS-1 C-Band and X-Band applications – For Standalone use, the cable connects the unit's 'J2 | RF OUT' port directly to the your
Rx signal destination. For 1:1 Redundancy applications, use the cable to connect each LPOD's 'J2 | RF OUT' port to the Tx Waveguide
switch.
•
For all LPOD applications – For Standalone use, the cable connects directly from these LPOD interfaces to your Rx signal destination or Tx
signal source. For 1:1 Redundancy applications, use the cable to connect the 'J1 | LBAND IN / Tx IN' or 'J10 | MODEM Rx' ports in 1:1
Redundancy applications to the system's respective signal splitters.
Figure B-7. 1/4" Heliax Coaxial Cable (CA/3722-X)
B-9
Revision 9
MN-LPOD