Comtech EF Data LPOD Installation And Operation Manual page 128

LPOD Outdoor Amplifier / Block Up Converter (BUC)
Serial-based Remote Product Management
Command Arguments
(Instruction for Command
Parameter Type
Code and or Response
Qualifier) to Query
IP Address IPA= 18 bytes
Gateway Address IPG= 15 bytes
Initialize Statistics ISP= None
Pointer
LNB Current LCS= 1 byte
Source
Description of Arguments
(Note that all arguments are printable ASCII characters)
Command or Query.
Sets or returns the IP address and network prefix for the 10/100 BaseT Ethernet management port, in the form
xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (8-30)
Default value: 192.168.001.004.24
Note: Changing the IP address through the Telnet interface requires the user to power cycle the unit, and then
restart a new Telnet session with the new IP address. The IP address that you type into the Telnet client
software does not include the range parameter so it would be: 192.168.1.4
Example: <1/IPA=192.168.001.004.24'cr'
>0001/IPA='cr''lf'
Command or Query.
Sets or returns the Gateway IP address for the 10/100 Base Tx Ethernet management port, in the form
xxx.xxx.xxx.xxx.
Default value: 192.168.001.005
Example: <1/IPG=192.168.001.005'cr'
>0001/IPG='cr''lf'
Command only.
Resets internal pointer to allow RNS? queries to start at the beginning of the stored statistics log.
Example: <1/ISP='cr'
>0001/ISP='cr''lf'
Command or Query.
Sets or returns the LNB current source in the form x, where:
x= 0,1,2,3 or 4:
0 = Disable (default value)
1 = Enable (18V 22kHz Disabled – Note 2)
2 = 18V 22kHz Enabled (Note 2)
3 = 13V 22kHz Disabled (Note 2)
4 = 13V 22kHz Enabled (Note 2)
Notes:
1. LCS must be enabled before the LNB current can be calibrated
2. This feature is available on multi-band units only.
Example: <1/LCS=1'cr'
>0001/LCS='cr''lf'
5–20
Revision 9
MN-LPOD
Response to Query
Response to Query
Command (Instruction
(Target to
(Target to Code and
Controller)
Controller) Qualifier)
IPA= IPA? IPA=
IPA? xx.xxx.xxx.xxx.yy
IPA*
IPA# (See Description of
Arguments)
IPG= IPG? IPG =
IPG? xxx.xxx.xxx.xxx
IPG*
ISP= N/A N/A
ISP?
ISP*
LCS= LCS? LCS=x
LCS? (See Description of
LCS* Arguments)