Wxb - Intel 460GX Software Developer’s Manual

2.4.6

WXB

2.4.6.1 ERRSTS: Error Status Register
Address Offset:
Default Value:
Sticky
This register records certain error conditions detected from the PCI bus. This register is sticky
through reset; that is, the contents of the register remain unchanged during and following the
assertion of XRST#. This allows system recovery software invoked following a forced reset to
examine the flags to determine the cause of an error. Once set, the flags remain set until explicitly
cleared by software or a power-good reset.
Note: Bits 6, 4, and 2 are Reserved on side-b and records a zero value only!
Bits
7
6
Note: This bit is Reserved on side-b and records a zero value only!
5
4
3
2
1
0
Intel® 460GX Chipset Software Developer's Manual
44h
00h
Description
INTRQ Asserted Flag
This flag is set if the WXB has initiated an INTRQ interrupt event. This bit remains set,
and the event signaled, until explicitly cleared by software writing a 1 to this bit.
Default = 0.
XBINIT Asserted Flag
This flag is set if the WXB has asserted XBINIT#. This bit remains set, and the event
signaled, until explicitly cleared by software writing a 1 to this bit. Default = 0.
NEPCI Register Records an PCI Bus Error Flag
This flag is set when the PCI bus reports an error (e.g. data parity error) on transactions
to/from other PCI bus agents. This bit remains set until explicitly cleared by software
writing a 1 to this bit. This bit is only set when the error is reported through the NEPCI
Next Error register, indicating that the error is not the first error occurrence since the
First Error register was last cleared. Default = 0.
reserved (0)
FEPCI Register Records an PCI Bus Error Flag
This flag is set when the PCI bus reports an error (e.g. data parity error) on transactions
to/from other PCI bus agents. This bit remains set until explicitly cleared by software
writing a 1 to this bit. This bit is only set when the error is reported through the FEPCI
register, indicating that the error is the first error occurrence since the FEPCI register
was last cleared. Default = 0.
reserved (0)
Performance Monitor #1 Event Flag
This flag is set when the Performance Monitor #1 detects an event. The
PCI_WXB_PMC1 registers describes the conditions that can cause this to occur. This
bit remains set until explicitly cleared by software writing a 1 to this bit. Default = 0.
Performance Monitor #0 Event Flag
This flag is set when the Performance Monitor #0 detects an event. The
PCI_WXB_PMC0 registers describes the conditions that can cause this to occur. This
bit remains set until explicitly cleared by software writing a 1 to this bit. Default = 0.
Register Descriptions
Size: 8 bits
Attribute: Read/Write Clear,
2-27