● After the crankcase bolts have been tightened,
check if the driveshaft and countershaft rotate
smoothly.
● If a large resistance is felt to rotation, try to free
the shafts by tapping the driveshaft or counter-
shaft with a plastic hammer as shown in Fig.
RIGHT ENGINE REASSEMBLY
CLUTCH
KICK START DRIVE GEAR AND IDLE GEAR
● Install the kick starter idle gear and drive gear.
Snap ring pliers : 09900-06107
GEAR SHIFTING CAM DRIVEN GEAR
When installing the gear shifting pawls into the cam
driven gear. The large shoulder � must face to the
outside as shown.
● Next, install cam guide and pawl lifter. Apply a
samll quantity of THREAD LOCK "1324"to the
threaded parts of the securing screws.
Thread Lock "1324"
�
�
ENGINE 3-44