Right Engine Reassembly - HYOSUNG GF125 Service Manual

3-47 SERVICING ENGINE

RIGHT ENGINE REASSEMBLY

KICK START DRIVE GEAR
AND IDLE GEAR
● Install kick starter idle gear and drive gear.
09900-06107
GEAR SHIFTING CAM DRIVEN GEAR
When installing the gear shifting pawls into the cam driv-
en gear. The large shoulder � must face to the outside
as shown.
● Next, install cam guide and pawl lifter. Apply a samll
quantity of THTEAD LOCK "1342" to the threaded
parts of the screws.
99000-32050
GEAR SHIFTING SHAFT
Install the gear shifting shaft. Match the center teeth of
the gear on the shifting shaft with the center teeth on
the shifting driven gear as shown.
NOTE:
After the cam driven gear, cam guide, gear shift-
ing shaft and neutral cam stopper have been fit-
ted, confirm that gear change is normal while
turning, the countshaft and driveshaft. If gear
change is not obtained, it means that assembly
of gears or installation of gear shifting fork is
incorrect. If this is the case, disassemble and
trace the mistake.
Snap ring pliers
Thread lock "1342"
A
A
TOP
4th
3rd
2nd
N
Low
A
A