HYOSUNG RX 125 Service Manual page 73

3-43 ENGINE
● When fitting the kick starter to the shaft, be sure
to align the punched marks..
● Fit the spring and washer on the shaft. Then,
insert the kick starter shaft into the crankcase.
Engage the pawl ② of kick starter guide ①.
● When fitting the kick return spring, hook the part
③ of return spring into the crankcase, turn it 1/2
a turn clockwise with the pliers and fit the part ④
of return spring into hole of the kick shaft. Then,
fit the spring guide and circlip.
CRANKCASE
When reassembling the crankcase pay attention to
the following.
● Coat SUPER GREASE "A"to the lip of oil seals.
● Remove sealant material on the fitting surface of
right and left halves of the crankcase and thor-
oughly remove oil stains.
● Fit the dowel pins on the half.
● Apply engine oil to the big end of the crankshaft
conrod and all parts of the transmission gears.
● Apply BOND "1215"uniformly to the fitting sur-
face of the left half of the crankcase, and after
waiting a few minutes, fit the right half on the
left half.
BOND "1215"
● ●
①
②
④
③