HYOSUNG RX 125 Service Manual page 116

AXLE SHAFT
Using the special tools, check the axle shaft for
runout and replace it if the runout exceeds the limit.
Dial gauge : 09900-20606
Runout of axle shaft
WHEEL RIM
Make sure that the wheel rim runout does not
exceed the service limit when checked as shown.
CAUTION
Worn or loose wheel bearing must be replaced
before attempting to true a wheel rim.
Dial gauge(1/100) : 09900-20606
Magnetic stand : 09900-20701
Runout of wheel rim
(Axial and Radial)
TIRE
Inspect the tires for wear and damage. Check the
tire tread depth as shown. Replace a badly worn or
damaged tire.
A tire with its tread worn down to the limit(in terms
of tread depth) must be replaced.
Tread depth
service limit
REASSEMBLY
Reassemble and remount the front wheel in the
reverse order of disassembly and removal, and also
carry out the following steps :
WHEEL BEARING
● Apply grease to the bearing before installing.
: Super grease "A"
● Install the wheel bearings by using the special
tool.
Bearing installer : 09913-75820
Service limit 0.25 mm
Service limit 2.0 mm
Front 1.6 mm
Rear 1.6 mm
CHASSIS 6-4