SPACER
Measure the inside diameter of the spacer with dial
calipers.
Spacer
(�, �:See page 6-31, 6-36)
If the inside diameter of the spacer exceeds the
service limit or flaws are discovered, replace the
spacer and O-rings.
REASSEMBLY
Reassemble the suspension, in the reverse order of
disassembly and removal, and also carry out the
following steps :
CUSHION LEVER BEARINGS
Install the right and left bearings by using the spe-
cial tool.
Bearing installer set : 09924-84510
CAUTION
When installing two bearings, punch marked
side of bearing comes on outside.
SPACER AND DUST SEAL
Apply grease to the spacer and dust seal before
installing, as shown in the illustration.
Super grease "A"
�
Service limit 14.20 mm
�
Service limit 10.20 mm
�
CHASSIS 6-34
�