Reed Valve; Engine Reassembly; Oil Seals - HYOSUNG Prima Service Manual

REED VALVE

When reinstalling the reed valve and stopper plate to
the body, align the both cut on the reed valve and stop-
per plate.
Apply THREAD LOCK " 1324 " to the stopper plate
securing screws.
Thread Lock " 1324 "

ENGINE REASSEMBLY

Reassembly is generally performed in the reverse order
of disassembly, but there are a number of reassembling
steps that demand or deserve detailed explanation or
emphasis. These steps will be taken up for respective
parts and components.

OIL SEALS

Fit the oil seals to the crankcase following the procedure
below.
Replace removed oil seals with new ones.
● Coat SUPER GREASE " A " to the lip of the oil seals.
Super Grease " A "
● Be sure to apply THREAD LOCK " 1324 " to outer
surfaces of right and left crankshaft oil seals to pre-
vent them from moving.
Thread Lock " 1324 "
● When fitting the oil seal in the crankcase, insert it
slowly with the special tools.
Oil seal installer : 09913 - 75830
Bearing installer attachment : 09924 - 74510
Bearing installer pilot : 09924 - 74540
NOTE:
Align the oil seal with edge � of the crankcase as
shown in the illustration.
ENGINE 3-22
3