HYOSUNG RX 125 Service Manual page 70

NOTE:
When reassembling the bearing retainer, apply a small quantity of THREAD LOCK "1324"to the threaded parts
of the bearing retainer screws.
In reassembling the transmission, attention must be given to the locations and positions of washers and circlips.
The cross sectional view given here will serve as a referance for correctly mounting the gears, washers and circlips.
COUNTERSHAFT
Mounting 2nd drive gear
● Press-fit 2nd drive gear into the countershaft.
Before reassembling, coat the internal face of the
2nd drive gear with THREAD LOCK "1324"and
install it so that the length � is as shown in Fig.
Thread Lock "1324"
Countshaft length �
(Low to 2nd)
CAUTION
This procedure may be performed only twice
before shaft replacement is required.
+0.1
mm
88.0
-0.2
ENGINE 3-40
Washers and circlips thickness.
� 1.2 mm � 1.0 mm
� 1.0 mm � 0.5 mm
� 1.0 mm
�