Table of Contents
Advertisement
6.6.1
Displaying the System Status
The RMC status command displays the system status and the current RMC settings.
Table 6–1 explains the status fields. See Section 6.11 for information on the commands
used to set the user-defined status fields.
RMC> status
RMC Runtime Firmware Revision: V0.6-5
RMC Booter Firmware Revision: V1.0-0
System Power: ON
System Halt: Deasserted
Escape Sequence: ^[^[RMC
Remote Access: Disabled
Modem RMC Defaults: Disabled
RMC Password: Not Set
Alerts: Disabled
Alert Pending: NO
Latest Alert: Fan failure
Init String:
Dial String: ATD72125
Alert String: pager #
User String: there is something wrong with my TS15 system
Com1 Baud:9600 Flow:SOFTWARE
Rmc:ENABLED
Logout Timer: 10 minutes
Voltage Status: OK
Thermal Status: OK
Warning Threshold:
65.00°C
Fan Status: OK
PCI Riser: Installed
POST DPR: OK
Watchdog Timer: Disabled
RMC>
hp AlphaServer TS15 Platform Status
Warning Alerts: Disabled
Mode:THROUGH
Thermal Shutdown: Enabled
60.00°C
Fan Shutdown: Enabled
NVRAM: OK
GPIOs: OK
Watchdog Reboot: Disabled
Using the Remote Management Console
Status: Not Initialized
Modem:DISABLED
Fatal/Power-Down Threshold:
LM75: OK
6-15
Advertisement
Table of Contents
Troubleshooting
