Console-Reported Failures; Table 7-5 Troubleshooting Console-Reported Failures - HP AlphaServer TS15 Owner's Manual

7.4

Console-Reported Failures

Table 7–5 Troubleshooting Console-Reported Failures
Symptom
Power-up tests do not complete.
Console program reports an
error.
7-6 hp AlphaServer TS15 Owner's Guide
Action
Use error beep codes or console serial terminal to
determine what error occurred.
Check the power-up screen for error messages.
Enter the RMC and use the poe command to check for
poweron errors; use the log or log # command to check
the event log for symptoms of failure.
Interpret the error beep codes at power-up and check
the power-up screen for a failure detected during self-
tests.
Examine the console event log (use the more el
command) to check for embedded error messages
recorded during power-up.
If the power-up screen or console event log indicates
problems with mass storage devices or PCI devices, or
if devices are missing from the show config display,
see Section 7.10.
Enter the RMC and use the poe command to check for
poweron errors; use the log or log # command to check
the event log for symptoms of failure.
Use the SRM test command to verify the problem.