Pk*0_Host_Id - HP AlphaServer TS15 Owner's Manual

5.20.9

pk*0_host_id

The pk*0_host_id environment variable sets the controller host bus node ID to a value
between 0 and 7.
Each SCSI bus in the system requires a controller. Buses can support up to eight devices;
however, the eighth device must be a controller. Each device on the bus, including the
controller, must have a unique ID, which is a number between 0 and 7. This is the bus node
ID number.
On each bus, the default bus node ID for the controller is set to 7. You do not need to
change the controller bus node ID unless you have two or more controllers on the same bus.
To list the controllers on your system, enter the show device command. SCSI controllers
begin with the letters "pk" (for example, pka0). The third letter is the adapter ID for the
controller. Replace the asterisk with the adapter ID letter when entering the set
pk*0_host_id command.
The value of pk*0_host_id takes effect only after you reset the system by pressing the Reset
button (if configured) or by issuing the init command. (Jumper J22 pins 13-14 must be
inserted for the halt/reset button to operate as a reset button.)
The syntax is:
set pk*_host_id scsi_node_id
The value for scsi_node_id is the bus node ID, a number from 0 to 7.
Example
In this example, the default bus node ID for a SCSI controller with an adapter ID of "b" is
set to bus node ID 6.
>>> set pkb0_host_id 6
>>> init
.
.
.
>>> show pkb0_host_id
pkb0_host_id 6
Using Firmware 5-51