Srm Environment Variables For Com1 - HP AlphaServer TS15 Owner's Manual

6.4

SRM Environment Variables for COM1

Several SRM environment variables allow you to set up the COM1 serial port for use
with the RMC.
You may need to set the following environment variables from the SRM console, depending
on how you decide to set up the RMC.
com1_baud
com1_flow
com1_mode
com1_modem
Sets the baud rate of the COM1 serial port. The default is
9600. See Table 6–1.
Specifies the flow control on the serial port. The default is
software.
Specifies the COM1 data flow paths so that data either flows
through the RMC or bypasses it. This environment variable
can be set from either the SRM or the RMC. The default for
com1_mode is through. See Section 6.11.
Specifies to the operating system whether or not modem
controls are to be utilized on COM1. The default for
com1_modem is off/disabled.
Using the Remote Management Console 6-11