Starting And Stopping Cpu; Halt (Or Stop); Example 5-11 Halt And Continue - HP AlphaServer TS15 Owner's Manual

5.13 Starting and Stopping CPU

Use the halt and continue commands to stop and continue a program on the CPU.
Example 5–11 Halt and Continue
>>> halt 00
halted CPU 00
halt code = 00
operator initiated halt
PC = ffffffff8007cc68
>>> continue &p0
continuing CPU

5.13.1 halt (or stop)

The halt (or stop) command stops program execution on a CPU that is running a booted
program. The syntax is:
halt (or stop) 00 (where 00 is the designated processor number)
The processor number is the designated CPU number displayed by the show cpu command.
5.13.2 continue
The continue command resumes program execution on the specified processor or on the
primary processor if none is specified. The processor begins executing instructions at the
address that is currently in the program counter (PC). The processor is not initialized.
The continue command is valid only if you have not disturbed the system state and if you
halted the system by pressing the halt/reset button on the control panel (Jumper J22 pins 13-
14 must not be installed for the halt/reset button to operate as a halt a button.) or, for
OpenVMS systems only, by entering Ctrl/P on the console terminal.
5-20 hp AlphaServer TS15 Owner's Guide