Eg*0_Mode, Ei*0_Mode, Or Ew*0_Mode - HP AlphaServer TS15 Owner's Manual

5.20.3 eg*0_mode, ei*0_mode, or ew*0_mode

The eg*0_mode or ei*0_mode or ew*0_mode environment variable sets an Ethernet
controller to run an AUI, ThinWire, or twisted-pair Ethernet network.
To list the network devices on your system, enter the show device command. The Ethernet
controllers start with the letters "eg", "ei," or "ew," for example, ewa0. The third letter is
the adapter ID for the specific Ethernet controller. Replace the asterisk (*) with the adapter
ID letter when entering the command.
The syntax is:
set eg*0_mode value or
set ei*0_mode value or
set ew*0_mode value
The options for ei*_mode and ew*_mode value are:
Aui
bnc
fast
Fastfd
full
twisted-pair
Auto-Sensing
Auto-Negotiate
5-44 hp AlphaServer TS15 Owner's Guide
Device type is AUI.
Device type is ThinWire.
Device type is fast 100BaseT.
Device type is fast full duplex 100BaseT.
Device type is full duplex twisted-pair.
Device type is 10BaseT (twisted-pair).
Sense and adjust to 10/100 MHz speed.
Automatically negotiates highest common performance with other
network controller(s) supporting IEEE 802.3u auto-negotiation.
If no Ethernet cable is connected in this mode, the SRM reports a
failure:
Error (eib0.0.10.0), No link, auto negotiation did not complete.
This is applicable for ei*, ew*, and eg* device in auto negotiate.