Clear Port - HP AlphaServer TS15 Owner's Manual

clear log
The clear log command clears all events from the system event log.

clear port

The clear port command clears the UARTs controlled by the RMC in an attempt to clear
any 'stuck' conditions that might exist.
disable alert
The disable alert command disables the RMC from paging the system operator in the event
that an alert condition is detected. System monitoring continues and any alert conditions
that are detected will still be logged.
disable fan
The disable fan command disables the system from powering off in the event that a fatal fan
failure occurs. By default, fan failures result in the system being powered off after a 3
minute lapse.
disable modemdef
This command instructs the RMC to use the user-supplied modem initialization string
without the additional commands that were automatically appended to the initialization
string on older AlphaServer and AlphaStation models.
disable reboot
The disable reboot command disables the watchdog timer from rebooting the system when
the watchdog timer expires. By default, the system does not reboot if the watchdog timer
expires.
disable remote
The disable remote command disables remote access to the RMC's modem port and
disables automatic dial-out.
disable thermal
The disable thermal command disables the system from powering off in the event that a
thermal failure occurs. By default, thermal failures powers off the system after a 3-minute
lapse.
Using the Remote Management Console 6-37