Table of Contents
Advertisement
User String:
Com1 Baud:9600
Rmc:ENABLED
Logout Timer: 20 minutes
Voltage Status: OK
Thermal Status: OK
Warning Threshold:
65.00°C
Fan Status: OK
PCI Riser: Installed
POST DPR: OK
Watchdog Timer: Disabled
RMC>
A typical alert situation might be as follows:
•
The RMC detects an alarm condition, such as over temperature failure.
•
The RMC dials your pager and sends a message identifying the system.
•
You dial the system from a remote serial terminal.
•
You enter the RMC, check system status with the env command, and, if the situation
requires, power down the managed system. (In many cases, a failure may have already
powered the system down.)
•
When the problem is resolved, you power up and reboot the system.
Flow:SOFTWARE
Mode:THROUGH
Thermal Shutdown: Enabled
60.00°C
Fan Shutdown: Enabled
NVRAM: OK
GPIOs: OK
Watchdog Reboot: Disabled
Using the Remote Management Console
Modem:DISABLED
Fatal/Power-Down Threshold:
LM75: OK
6-27
Advertisement
Table of Contents
Troubleshooting
