Set Envar; Show Envar - HP AlphaServer TS15 Owner's Manual

set envar

The set command sets or modifies the value of an environment variable. It can also be used
to create a new environment variable if the name used is unique. Environment variables pass
configuration information between the console and the operating system. Their settings
determine how the system powers up, boots the operating system, and operates. The syntax
is:
set envar value
envar The name of the environment variable to be modified. See
Table 5–6 for a list of commonly used environment variables.
value The new value of the environment variable.
New values for the following environment variables take effect only after you reset the
system by pressing the Reset button (if configured) or by issuing the init command. (Jumper
J22 pins 13-14 must be installed for the halt/reset button to operate as a reset button.)
console
os_type
pk*0_fast
pk*0_host_id
pk*0_soft_term

show envar

The show envar command displays the current value (or setting) of an environment
variable. The syntax is:
show envar
envar The name of the environment variable to be displayed. The show *
command displays all environment variables.
Using Firmware 5-39