Figure 4-8 Replacing A Front Access Tape Drive - HP AlphaServer TS15 Owner's Manual

Figure 4–8 Replacing a Front Access Tape Drive
2
CAUTION: Before removing a drive, make sure that its activity LED is off.
Replacing a Front Access Tape Drive
1. Verify that the tape drive is not in use (the activity LED is off).
2. To remove the drive, press the locking tab
3. Pull on the handle
with the tape drive.
4. Snap the new plastic filler onto the new tape drive.
5. Insert the new tape drive into the cage. With the drive resting on top of the rail guides of
the cage, slide the drive in until it stops.
6. Push the handle
snaps into place.
Verification
You must enter the SRM and use the init and show device commands to verify that the
system sees the new drive.
3
1
MR0658
to remove the drive from the cage. A plastic filler
to make the backplane connection. Verify that the locking tab
to the left to disengage the tape drive.
Installing and Configuring Options
slides out
4-11