HP AlphaServer TS15 Owner's Manual page 92

Replacing the Top Cover
CAUTION: Avoid injury by keeping fingers away from the right (captive screw) edge of
the cover.
1. Rotate the enclosure so its left side slightly overhangs the edge of the tabletop.
2. Referring to preceding Figure 4–3, engage the four tabs on the left side of the cover
with the slots on the lower left side of the enclosure. Lower the cover until the right
edge rests on the enclosure.
3. While pushing the left side of the cover against the enclosure, push the right (captive
screw) edge down until it is fully seated.
4. As shown in the preceding figure, install the three M4 screws
the enclosure and tighten the three captive screws
Reinstalling the Enclosure
1. Slide the enclosure into the rack. Be sure to align the rear tabs
shown in Figure 4–2.
2. As shown in the same figure, insert the four screws
the rack.
3. As show in Figure 4–1, install the front bezel by inserting the four screws
enclosure's face panel
4. Go to the rear of the cabinet, locate the back panel of the AlphaServer TS15 enclosure,
and connect the ground cable and all other cables to the enclosure. Connect both power
connectors. (Refer to Figure 1-15 for details.)
5. Turn on system power by pressing the power switch on the operator control panel. Boot
the operating system.
4-6 hp AlphaServer TS15 Owner's Guide
. Close the front door and tighten the thumbscrews
on the hinged side of
on the other side to 13-15 ft.-lb.
with the rack slides as
that fasten the enclosure to
into the
.