Using Power On And Off, Reset, And Halt Functions - HP AlphaServer TS15 Owner's Manual

6.6.3

Using Power On and Off, Reset, and Halt Functions

The RMC power {on, off}, halt, and reset commands perform the same functions as the
buttons on the operator control panel.
Power On and Power Off
The RMC power on command powers the system on, and the power off command powers
the system off. The Power button on the OCP, however, has precedence.
•
If the system has been powered off with the Power button, the RMC cannot power the
system on. If you enter the power on command, the message "Power-On Error: Cannot
power on system when power button is off" is displayed, indicating that the command
will have no effect.
•
If the system has been powered on with the Power button, and the power off command
is used to turn the system off, you can toggle the Power button to power the system
back on.
When you issue the power on command, the terminal exits RMC and reconnects to the
server's COM1 port.
RMC> power on
Returning to COM port
hp AlphaServer TS15 Remote Management Controller - Revision V1.1-0
RMC> power off
RMC>
6-20 hp AlphaServer TS15 Owner's Guide