Com*_Baud - HP AlphaServer TS15 Owner's Manual

5.20.1 com*_baud

The default baud rate for the system is 9600. The com*_baud commands set the baud
rate for COM1 and COM2.
com1_baud
The com1_baud environment variable sets the baud rate for the internal COM1 serial
interface.
com2_baud
The com2_baud environment variable sets the baud rate to match that of the device
connected to the COM2 port.
The syntax is:
set com*_baud baud_value
baud_value The new baud rate. A list of possible values is displayed by entering the
command without a value.
Example
The following example shows the supported baud rate values.
>>> set com2_baud
57600
38400
19200
9600
7200
4800
3600
2400
2000
1800
.
.
.
NOTE: SROM power on output will not display correctly unless COM1 is set to 9600.
5-42 hp AlphaServer TS15 Owner's Guide