Figure 28 Lt Function Configuration; Enhanced Function Configuration; Instance Configuration - Zte ZXR10 5900 Series User Manual

Command
show ma {all |( session <1-32>)} md <1-16>
ZXR10#
Command
show mp {all |<1-64>}md <1-16> ma <1-32>
ZXR10#
Step Command
1
debug cfm pkt {all | (megid md <1-16>
ZXR10#
ma <1-32> mep <1-8191>) }[{[direction {send
|rcv|alll}],[pkt-nums <10-100>],[time-interval
<4-10000>]}]
2
ZXR10(config-gei_1/x)#
3
clear pbt-cfm
ZXR10(config)#
6. To show MP information, use the following command.

Enhanced Function Configuration

cfm-mac <xxxx.xxxx.xxxx>

Instance Configuration

The three switches use LT function.
The network figure is shown as
F 28 LT F
IGURE UNCTION
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 11 Ethernet OAM Configuration
Function
show all MAs in one MD or a
certain MA once.
Function
Only can show a certain MD,
one or all MPs in a certain MA.
Function
This opens Debug function.
In management mode, print
all receiving and sending
packets of all mep related
ports or only print one or
several receiving, sending or
receiving/sending packets in
one mep selectively (default
is 10), but the time interval
of printing packet can be
4-10000ms.
This configures port MAC.
The mac must be the one that
related to the rack.
This clears all CFM
configurations.
after executing this
command, can't see any
CFM configuration information
by show run.
Figure 28:
C
ONFIGURATION
101