Configuring One-Way Pvlan; Configuring Zesr; Configuration Example - Zte ZXR10 5900 Series User Manual

ZXR10 5900/5200 Series User Manual (Ethernet Switching Volume)
Step Command
1
ZXR10(config)#
session-id <id> source <port-list> destination
<port-list>
2
ZXR10(config)#
session-id <id>
3
ZXR10(config)#
nal
Example
28 Confidential and Proprietary Information of ZTE CORPORATION

Configuring One-Way PVLAN

To configure to forbid uplink port of SVLAN based on ACL to forward
data to loopback port, use the following commands.
vlan private-map-unidirectional
no vlan private-map-unidirectional
show vlan private-map-unidirectio
Note:
1. Uplink data packet is forwarded by customer port and broad-
cast in SPVLAN after looped by loopback port. To prevent cus-
tomer port from receiving data message looped by loopback
port, generally, configure a one-way PVLAN data whose source
port is loopback port and destination port is customer port.
2. Downlink data packet is forwarded directly to customer port
information by uplink port, needn't be forwarded to loopback
port. To avoid that the data packet that uplink port forwards
to loopback port loops and is forwarded to uplink port again,
must configure a one-way PVLAN data whose source port is
uplink port and destination port is loopback port.
This example shows how to configure one-way PVLAN.
ZXR10(config)#vlan private-map-unidirectional session-id 1
source gei_1/3-4 destination gei_1/2
ZXR10(config)#vlan private-map-unidirectional session-id 2
source gei_1/2 destination gei_1/1

Configuring ZESR

Refer to ZESR related chapter.

Configuration Example

1. Configure gei_1/1 as customer port on the switch, the CVID
which receives data packet is VLAN 10, configure gei_1/3/ and
gei_1/4 as uplink port, the SPVID which forwards data packet
is VLAN 100, configure SVLAN based on ACL and configure
Function
This configures one-way
PVLAN source port and
destination port.
This cancels one-way PVLAN
configuration.
This displays the configuration
information of one-way
PVLAN.