Configuring Preup Time; Configuring Zess Mode - Zte ZXR10 5900 Series User Manual

Parameter
<1-600>
<primary-interface-name><s
econdary-interface-name>
Example
Command
zess domain < 1-4> preup <1-600>
ZXR10(config)#
Parameter
<1-600>
Example
Command
zess domain <1-4> mode {revertive |
ZXR10(config)#
non_revertive}
Description
Preforward value, the unit is second. When the disconnected
port reconnects, wait for preforward time and open
automatically unless has ZESR protocol configuration. The
default value is 10 seconds.
Two ports of ZESS. In normal cases, secondary port is block,
which avoids forming storm.
1. Create zess node that domain is 1, protect-instance is 1 ,ports
are gei_1/10 and gei_1/20.
ZXR10(config)# zess domain 1 protect-instance 1
primary gei_1/10 secondary gei_1/20
2. This deletes zess that domain is 1.
ZXR10(config)# no zess domain 1

Configuring Preup Time

To configure preup time of zess node, use the following command.
Paramters Description
Description
Preup value, the unit is second. After ZESS detects that link
recovers, it doesn't switch state quickly until delaying preup
time. The default value is 5 seconds.
This example shows how to configure domain 1 preup time as 10
seconds.
ZXR10(config)# zess domain 1 preup 10

Configuring ZESS Mode

To configure ZESS mode as inversion or non-inversion mode, use
the following command.
Paramters Description
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 10 ZESS Configuration
Function
The default preup time is 5
seconds.
Function
This configures ZESS mode
as inversion or non-inversion
mode.
83