Configuring Link Aggregation - Zte ZXR10 5900 Series User Manual

ZXR10 5900/5200 Series User Manual (Ethernet Switching Volume)
Step Command
1
ZXR10(config)#
2
ZXR10(config--smartgroupX)#
802.3ad|on}
ZXR10(config-gei_1/x)#
mode {passive|active|on}
ZXR10(config--smartgroupX)#
<mode>
62 Confidential and Proprietary Information of ZTE CORPORATION
The logic port formed by link aggregation on the ZXR10 5900/5200
is called smartgroup, which can be used as a common port.
Configuring Link
Aggregation
1. To create a trunk group, use the following command.
interface smartgroup<1-32>
smartgroup mode{
2. To add a member port to the trunk group and set the port
aggregation mode, use the following command.
smartgroup <smartgroup-id>
When aggregation mode is set to on, port runs static trunk and
both ends taking part in aggregation should be set to on.
When aggregation mode is set to active or passive, port runs
LACP. Active indicates a port is in active negotiation mode. Pas-
sive indicates a port is in passive negotiation mode. When con-
figuring dynamic link aggregation, set the aggregation mode
of one end to active and that of other to passive or both ends
to active.
Note:
VLAN link type of member port must be consistent with that of
smartgroup. Otherwise, port is not allowed to join trunk group.
3. To set load balance mode for port link aggregation, use the
following command.
smartgroup load-balance
Port link aggregation of ZXR10 5900/5200 supports six load
balance modes. They are based on source and destination IP
addresses, source and destination MAC addresses, as well as
source and destination ports. By default, load balance mode is
based on source and destination MAC addresses.
4. To delete sm, use the following command.
Function
This creates a trunk group.
This creates smartgroup
mode.
This adds a member port to the
trunk group and sets the port
aggregation mode.
This sets load balance mode for
port link aggregation.